RayonixHs Tango device

This is the reference documentation of the RayonixHs Tango device.

you can also find some useful information about the camera models/prerequisite/installation/configuration/compilation in the RayonixHs camera plugin section.

Properties

Property name	Mandatory	Default value	Description
frame_mode	No	single	The frame mode, single or fast_transfer
frame_trigger_signal_type	No	opto	The frame trigger signal type (input #1)
sequence_gate_signal_type	No	opto	The gate signal type (input #2)
electronic_shutter_enabled	No	false	The electronic shutter true or false to activate or not
cooler_temperature_setpoint	No	-120	The cooling system temperature setpoint in Celsuis
sensor_temperature_setpoint	No	-80	The detector (sensor) temperature setpoint in Celsuis
output1_signal_type	No	cmos	The output #1 signal type
output2_signal_type	No	cmos	The output #2 signal type
output1_id	No	shutter	The output #1 signal source
output2_id	No	frame	the output #2 signal source

The Rayonix HS input/output system supports different type of signals:

• OPTO/OPTO_INVERTED/CMOS/CMOS_PULLDOWN/CMOS_PULLUP/CMOS_PULLDOWN_INVERTED/CMOS_PULLUP_INVERTED

And it provides a output multiplexer for both outputs within the following list of sources:

• SHUTTER/INTEGRATE/FRAME/LINE/SHUTTER_OPENING/SHUTTER_CLOSING/SHUTTER_ACTIVE/TRIGGER_RISE_WAIT/TRIGGER_RISE_ACK/TRIGGER_FALL_WAIT/TRIGGER_FALL_ACK/TRIGGER_2_RISE_WAIT/TRIGGER_2_RISE_ACK/INPUT_FRAME/INPUT_GATE

Attributes

Attribute name	RW	Type	Description
frame_mode	rw	DevString	The frame mode, single or fast_transfer
frame_trigger_signal_type	rw	DevString	The frame trigger signal type (input #1)
sequence_gate_signal_type	rw	DevString	The gate signal type (input #2)
electronic_shutter_enabled	rw	DevString	The electronic shutter true or false to activate or not
cooler_temperature_setpoint	rw	DevDouble	The cooling system temperature setpoint in Celsuis
sensor_temperature_setpoint	rw	DevDouble	The detector (sensor) temperature setpoint in Celsuis
output1_signal_type	rw	DevString	The output #1 signal type
output2_signal_type	rw	DevString	The output #2 signal type
output1_id	rw	DevString	The output #1 signal source
output2_id	rw	DevString	The output #2 signal source
vacuum_valve	rw	DevString	The vacuum valve command true or false to open or close

Warning: be careful with the temperature setting (and vacuum valve), the operating temperature is factory-determined and should never be changed. There is no reason to run the detector at a warner temperature.

For the signal type and source the possible values are listed above in the Properties section.

Commands

Command name	Arg. in	Arg. out	Description
Init	DevVoid	DevVoid	Do not use
State	DevVoid	DevLong	Return the device state
Status	DevVoid	DevString	Return the device state as a string
getAttrStringValueList	DevString: Attribute name	DevVarStringArray: String value list	Return the authorized string value list for a given attribute name