Andor3 Tango device ===================== This is the reference documentation of the Andor3 Tango device. you can also find some useful information about prerequisite/installation/configuration/compilation in the :ref:`Andor3 camera plugin ` section. Properties ---------- ================= =============== =============== ========================================================================= Property name Mandatory Default value Description ================= =============== =============== ========================================================================= config_path Yes N/A The configuration path, for linux default is /usr/local/etc/andor/bitflow camera_number Yes N/A The camera number range is [0-N] adc_gain No N/A The ADC gain setting, see attribute for possible values adc_rate No N/A The ADC readout rate, see the attribute for possible values temperature_sp No N/A The sensor temperature set-point cooler No N/A To start/stop the cooler, values ON or OFF ================= =============== =============== ========================================================================= Attributes ---------- ======================= ======= ======================= ====================================================================== Attribute name RW Type Description ======================= ======= ======================= ====================================================================== adc_gain rw DevString ADC/Gain pair settings : - **B11_HI-GAIN** - **B11_LOW_GAIN** - **B16_LH_GAIN** adc_rate rw DevString The ADC rate: - **MHZ10** - **MHZ100** - **MHZ200** - **MHZ280** electronic_shutter_mode rw DevString The electronic shutter: - **GLOBAL** - **ROLLING** cooler rw DevString Start/stop the cooling system of the camera mode: - **ON**, the cooler is started - **OFF**, the cooler is stopped cooling_status ro DevString The status of the cooling system, tell if the setpoint temperature is reached fan_mode rw DevString The FAN mode for extra-cooling: - **OFF** - **LOW** - **HIGH** frame_rate ro DevDouble The current frame rate, depends of exposure and latency time max_frame_rate_transfer ro DevSouble The rate transfer of the camera interface card, can be lower than the camera frame rate readout_time ro DevDouble The readout time of the camera sensor overlap rw DevString To enable or disable the overlap mode: - **ON** - **OFF** spurious_noise_filter rw DevString To enable or disable the spurious noise filter mode: - **ON** - **OFF** temperature ro DevShort The current sensor temperature in Celsius temperature_sp rw DevShort The temperature setpoint in Celsius ======================= ======= ======================= ====================================================================== Commands -------- ======================= =============== ======================= =========================================== Command name Arg. in Arg. out Description ======================= =============== ======================= =========================================== Init DevVoid DevVoid Do not use State DevVoid DevLong Return the device state Status DevVoid DevString Return the device state as a string getAttrStringValueList DevString: DevVarStringArray: Return the authorized string value list for Attribute name String value list a given attribute name ======================= =============== ======================= ===========================================